When installing PVC Seal, in order to ensure the sealing effect, you need to pay attention to the following aspects:
1. Preparation before installation
First, clean the installation site. Make sure that there are no impurities such as dust, oil, rust, etc. on the installation surface, because these impurities will affect the adhesion and sealing performance of the sealing strip. You can use a clean cloth or detergent to clean it, and install it after the surface is completely dry. At the same time, check whether the size of the sealing strip matches the installation site to avoid loose installation or inability to install due to size mismatch. Before installation, you can also leave the sealing strip at room temperature for a period of time to adapt it to the temperature of the installation environment to prevent deformation of the sealing strip due to temperature changes.
2. Correct installation method
When installing, install it correctly according to the design requirements of the sealing strip. For different types of sealing strips, the installation method may be different. For example, some sealing strips need to be inserted into the installation groove. At this time, ensure that the insertion depth is uniform to avoid partial insertion too deep or too shallow. For adhesive sealing strips, ensure that the adhesive surface is clean and dry, and use appropriate glue or double-sided tape for adhesive. During the pasting process, apply uniform pressure to make the sealing strip fully contact with the installation surface to ensure that the pasting is firm. At the same time, pay attention to the installation direction of the sealing strip to ensure that its sealing part is completely in line with the part that needs to be sealed.
3. Inspection after installation
After the installation is completed, the sealing effect of the sealing strip should be checked. You can judge whether the sealing effect is good by visual inspection, hand inspection or simple sealing test. Visual inspection mainly observes whether the sealing strip is installed flat, wrinkle-free and gap-free. Hand inspection can gently press the sealing strip to feel its elasticity and sealing strength. If conditions permit, a sealing test can be performed, such as spraying water on the sealing part or using air pressure detection equipment to check whether there is water leakage or air leakage. If the sealing effect is found to be poor, find the cause in time and adjust or reinstall it.
4. Daily maintenance
In order to maintain the sealing effect of PVC Seal, daily maintenance is also required. Avoid exposing the sealing strip to sunlight or high temperature for a long time to avoid accelerating its aging and deformation. Clean the surface of the sealing strip regularly to prevent dust and dirt from accumulating and affecting the sealing performance. If the sealing strip is found to be damaged or aged, it should be replaced in time to ensure the continuous stability of the sealing effect.
In short, when installing PVC Seal, only by paying attention to the above links can the sealing effect of the sealing strip be ensured and the performance and service life of the product be improved.
